System-Defined Device Drivers : Supported IPv4 IP Route commands
  
Supported IPv4 IP Route commands
The following table lists the commands that are included in the system-defined device drivers. For certain device drivers, additional variations of the IPv4 IP Route commands can be imported into NetIM. The following table lists IPv4 IP Route commands for device drivers that support multiple forms of the command.
Device driver
Supported command output
Cisco Systems
show ip route*
show ip route <protocol>
show ip route <protocol> <process id>
show ip route bgp {param}
show ip route vrf <vrfname>
show ip route vrf <vrfname> <protocol> {param}
where <protocol> is:
{bgp | dhcp | egp | eigrp | igrp | isis | mobile | odr | ospf | rip | connected | static}
Juniper
show route1
show route <protocol>
where protocol is:
{bgp | direct | esis | isis | ldp | local | ospf | rip | rsvp | static}
VRF information (such as green.inet.0) is parsed from the output.
Juniper ERX
show ip route1
show ip route <protocol>
where <protocol> is:
{access | access-internal | bgp | bgp-internal | dvmrp | isis | ldp | local | mbgp | ospf | other | rip | rsvp | static | static-rpf}
Foundry Networks
show ip route1
show vrf
The VRF name is not parsed from the output.
* This is the variant of the ip route command that appears in the device driver by default.